Karcher Concrete Remover

Karcher Concrete Remover effectively removes concrete splatters and deposits from construction vehicles, equipment, tools and commercial surfaces. Not intended for use on fine automotive finishes. Always pre-test undiluted product in an inconspicuous area, to determine safety and suitability for the intended use.

Quick Specs

• Light yellow liquid
• Sharp scent
• Medium foaming action
• 2.16 pH level (full strength)
• 2.0 pH level (1:150 dilution ratio)

Dilution Ratio

• 1:1
• 5 gallons makes 10 gallons

To Apply

• Spray diluted solution on surface and allow to penetrate, but not dry
• Apply detergent from the bottom up and rinse from the top down

Directions

• INDUSTRIAL USE ONLY
• Read the Safety Data Sheet thoroughly before using this product
• Do not pre-wet surfaces to be treated, as this will decrease the rate of concrete removal
• Apply Concrete Remover undiluted to affected areas, using a pump sprayer or a soft chemical-resistant bristle brush
• For fresh light splatters, dilute product 1:1 (pH 2.0 at dilution)
• Allow 15 minutes dwell time for concrete to soften. Rinse surfaces thoroughly with fresh clean water
• Use of a high pressure washer will assist with removal and rinsing
• Allow all surfaces to dry before the re-treatment of any heavier concrete deposits

Sizes Available

• 5 gallon bucket: 8.698-139.0, 86981390
• 55 gallon drum: 8.698-140.0, 86981400